Nav: Home
Welcome, Guest. Please login or register.
Did you miss your activation email?
May 27, 2012, 02:02

Login with username, password and session length

MicrostockGroup

Microstockgroup Sponsors


« previous next »
Pages: [1] Print

Topic: ISO too High?  

(Read 1582 times)
bobkeenan

Dreamstime GaugeiStock Gauge
« on: June 10, 2010, 11:08 »

Ouch.... Just had 12 of 12 photos rejected.   Mostly noise and focus.

Shutterstock is my best site.  I usually have 60-100% acceptance.  It is really rare to get 100% rejection.  I have been a contributor for about 18 months now.

One thing that was different about this batch is that most were new hand held Macros from a new 100mm f2.8 macro lens that I had just gotten.  I am new to  macro shooting.  One thing that I found is that there is almost NEVER enough light.  I don't use flash (maybe I should).  So.... while I normally shoot at ISO 100 in a non-Macro lens.... I pushed it to 250-400 for these shots on my Canon 7D.  In well lit areas there was no noticeable noise. But the shadows had noise and at 400 it was bad noise.   Noise reduction took care of most of it and for the bad areas I added some light blurring.

Also my DOF was more narrow than normal due to the lack of light and distance to the subject.  I thought that added to the "feel" of the image.  But it was different than my normal stuff.

I thought the images looked good. Maybe the bokeh was a little unnatural?

So I am wondering..... did I get a reviewer who had a bad day or just did not like these kind of shots  OR  did they see the larger ISO and that increased my chances of rejection?


Ignore | Logged


DepositPhotos.com
epantha
« Reply #1 on: June 10, 2010, 11:16 »

I also have a 100mm Macro lens and there are a lot of pics in my portfolio using that lens. I use noise reduction software on the 400 ISO photos and reduce them to 2000-3000 px on the long side. I've found that SS doesn't like short depth of field pics like IS does.
« Last Edit: June 10, 2010, 11:24 by epantha »

Ignore | Logged


Fred


Dreamstime GaugeiStock Gauge
« Reply #2 on: June 10, 2010, 12:28 »

Hand holding may also be a problem.  My understanding is that for macro shooting image stabilization/vibration reductions does not work very well. 

fred


Ignore | Logged


WarrenPrice

Dreamstime GaugeiStock Gauge
« Reply #3 on: June 10, 2010, 12:43 »

Hand holding may also be a problem.  My understanding is that for macro shooting image stabilization/vibration reductions does not work very well. 

fred

My thoughts as well.  I use a tripod, the lowest ISO possible, and get a lot of DOF via f11~f22. 
Still, get "focus" rejects at SS.  They are picky.   Lips sealed


Ignore | Logged


RacePhoto



« Reply #4 on: June 10, 2010, 15:22 »

Hand holding may also be a problem.  My understanding is that for macro shooting image stabilization/vibration reductions does not work very well. 

fred

My thoughts as well.  I use a tripod, the lowest ISO possible, and get a lot of DOF via f11~f22. 
Still, get "focus" rejects at SS.  They are picky.   Lips sealed

Just found out too late that shallow depth of field, like a caterpillar on a tall stalk of grass where the subject is perfectly sharp and the hairs are all individually clear will get rejected on SS for out of focus. OK, lesson learned. Where were you guys last week, before I sent it in?  Wink


Ignore | Logged


Perry



« Reply #5 on: June 10, 2010, 16:34 »

 In well lit areas there was no noticeable noise. But the shadows had noise and at 400 it was bad noise.

Shadows aren't more noisy, it's your post processing (fiddling with levels/curves etc.) that causes it. If the image is correctly lit and exposed there is no need to bump up the lightness in the shadows.


Ignore | Logged


bobkeenan

Dreamstime GaugeiStock Gauge
« Reply #6 on: June 10, 2010, 19:28 »

 In well lit areas there was no noticeable noise. But the shadows had noise and at 400 it was bad noise.

Shadows aren't more noisy, it's your post processing (fiddling with levels/curves etc.) that causes it. If the image is correctly lit and exposed there is no need to bump up the lightness in the shadows.

Hmmmm.  Beg to differ....   Without ANY post processing.....  If you take a series of shots of an image with darker areas or shadows,  AND if you increase ISO with each shot in Av or M mode,  You WILL start to see noise in the darker areas first and it will get worse at the higher ISO's.  Eventually you will then see it in the well exposed areas too.

I do agree that post processing will cause noise too but, to me,  this is more like artifacts.  These look more like squiggles and lines rather than the random noise that you get with High ISO sensor noise.

Correct me if you think I am wrong on this please?  I still have lots to learn.


Ignore | Logged


PaulieWalnuts


iStock Gauge
« Reply #7 on: June 10, 2010, 21:39 »

 In well lit areas there was no noticeable noise. But the shadows had noise and at 400 it was bad noise.

Shadows aren't more noisy, it's your post processing (fiddling with levels/curves etc.) that causes it. If the image is correctly lit and exposed there is no need to bump up the lightness in the shadows.

I would partially agree with this.

I've had a few different cameras. With some the shadow noise was consistently poor. My main camera now rarely has any shadow noise issues. Also depends on jpeg vs raw and the raw conversion software used.

Exposure and levels/curves definately have an influence on it.


Ignore | Logged


Colette


« Reply #8 on: June 11, 2010, 06:32 »

Perry: Yes, there is..., strange enough! I am not very satisfied with the amount of noise on the 7D. Even at ISO 100 there's some noise (a  400D has none on ISO100!).
And there is indeed more noise in the unsharp and darker areas. Don't understand how that is possible.
I expected better results from this camera when it comes to noise. But I must say that it is soft noise and easy to remove. Exposing to the right also helps. The more strange is that highest quality jpg straight from the camera has less noise than raw!

The example images (with no post processing) on the internet made on high ISO are misleading or I own a 7D with bad sensor.
This is my second 7D. With the first one no sharp image could be made and the noise was terrible. I brought it back to the store and they have send it back to Canon.
 For I know no one who has one too, I have no possibility to get comparative material.   


Ignore | Logged


bobkeenan

Dreamstime GaugeiStock Gauge
« Reply #9 on: June 12, 2010, 09:15 »

I think it was more a reviewer issue than noise or focus.  I sent in a 2nd batch.  Same lens, same exposures, same subjects but slightly different compositions.  The first batch 100% rejection, the second batch 70% acceptance !

But I think my images were not as good as they should be and in the future, for my Macros, I will try to use the tripod and use a flash or reflector for more light.. lower ISO.


Ignore | Logged


Microstock InsiderEnvateo Photo Tools
Pages: [1] Print 
« previous next »
Jump to:  


Related Topics
Subject Started by Replies Views Last post
Really high sales so far in May (4th)
CanStockPhoto.com
Lee Torrens 6 2332 Last post May 16, 2007, 20:29
by tsmarkley
High Fives!
Microstock News
Istock News 0 639 Last post October 24, 2007, 18:52
by Istock News
Semi new at stock, in high need for pieces of advice ;-)
General Stock Discussion
Autumnleaves 15 2215 Last post October 06, 2010, 13:22
by microstockphoto.co.uk
Deducted royalities -- surprisingly high %
DepositPhotos
Danicek 3 1286 Last post January 27, 2011, 06:25
by Danicek
High acceptance = low sales?
General Stock Discussion
seawhisper 7 1172 Last post March 09, 2011, 06:35
by seawhisper

TinyPortal v1.0.5 beta 1© Bloc